RING 4 LAYOUT

Here is the basic layout for Ring 4. Side1 is a finished edge on the plywood.
Side2 is drawn parallel to Side1 and marks the distance across the piece to
the opposite flat edge. This is NOT the ring diameter across the center point,
but the width between the flats needed to clear the battery boxes on the feet.
Side2 will be cut with a circular saw before using the router to cut the outer
round of the ring relative to the center point.

NEXT BACK

JEDI CAFETERIA
There is no oleo,
there is grease.
No insta-grits,
there is pooridge.
No 'passion fruit',
only Snapple.
There is no crime,
in leaving a tip.

No Shoes, No Saber,
No service.

NOVEMBER 7th 2004

The content of this page is original to its creator except where noted. Certain copywritten terminology is present as allowed under fair useage guidelines. This site depicts the efforts of a fan to create replicas of copywritten characters and original 'one-off' creations. These are expressly for personal, and not profesional use. Nothing depicted here is offered for sale via this site. The creator receives no finacial benefit from the sale or manufacture of anything depicted here, either from the sites creator or any other party. No infringment of personal, legal, or intellectual property is intended or implied. So help me God.